Pumping Depth (DTW)
Gallons Per Minute
|90||END OF WIRE|
The 12 Volt Remediation Poseidon Pump
A 12 volt battery or solar operated submersible water pump that easily fits into a 2 inch well.
A revolutionary 12 volt pump: The Poseidon™ 12 volt submersible pump by Proactive Environmental Products® is engineered for the pump tests and groundwater remediation. The Poseidon series pump line will fit into a schedule 40 or 80 2inch well. There are three models that we have engineered. The first pump is called the Poseidon 100 (pumps 100 feet depth to water). The second pump is called the Poseidon 80 (pumps 80 feet depth to water) and the third pump is called the Poseidon 60 (pumps 60 feet depth to water). They are truly so simple to install and operate: Just hose clamp onto the pump barb tip a 3/8" id polyethylene tubing and attach your desired suspension rope to the eye hook provided on top of the pump. Then, lower the pump to the desired water depth and energize the pump with a deep cycle marine battery and/or a small solar system. Also, you can hook up the Poseidon pump to our weatherproof 110 volt step down transformer (item #TR-12500).
Easy to fix if a problem should arise: Let's face it, mechanical parts break down after a while. The life expectancy of the motor module is around 400 hours or so. Please Keep in mind... the life of the pump depends of course how often it is used (this is for any pump or a matter of fact anything mechanical). The great benefit of the Poseidon Pump Series is the patented (#7584785) replaceable motor module that can be changed out within 60 seconds. That means no down time and NO expensive service calls. Just twist in the new motor module and start pumping again, truly peace of mind!! Once the new motor module is installed, your pump is essentially new and will have a life span identical to a new pump. Please note, the Poseidon pump ships to you with one motor module installed on the pump. If you need to purchase a back-up motor module please contact your Proactive Environmental Products® authorized distributor.
The Poseidon 60, 80 & 100 pumps are engineered for ease of use. The pumps consist of 4 components:
- The replaceable motor module
- The motor module housing top connector
- The outside pump housing
- The pump power wire
Here are the Specifications for the Poseidon 60, 80 & 100 Pumps:
TESTS WERE CONDUCTED USING A 50 AMP DEEP CYCLE MARINE BATTERY THAT HAS A CONSTANT VOLTAGE OF 12.5 AT THE BATTERY TERMINALS.
DTW=DEPTH TO WATER OR TRUE PUMPING DEPTH. FOR EXAMPLE: IF THE STAGNANT WATER COLUMN IS 60 FEET, THEN THE PUMP WILL BE ABLE TO LIFT A TRUE 1.4 GPM PER MINUTE (REFERENCING THE Poseidon 80) (PLUS OR MINUS A LITTLE BIT, DEPENDING UPON THE VOLTAGE OUTPUT OF THE BATTERY).
The Poseidon Pump series is constructed from ABS/PVC and Stainless steel.
Sometimes the specifications and color of the pumps will change without notice. (Poseidon® 100 Booster above)
THE Poseidon 60 PUMP WIRE MAY BE CUT DOWN TO ANY SPECIFIC LENGTH. BUT THE Poseidon 80 & 100 PUMP YOU CANNOT CUT THE WIRE DOWN TO SHORTER LENGTHS.DOING SO WILL OVER AMP AND OVER VOLT THE MOTOR MODULE CAUSING PREMATURE FAILURE!!
WHEN USING THE Poseidon 80 PUMP... ONLY USE THIS PUMP AT DEPTHS OF 40 FEET DTW OR DEEPER. FAILURE TO DO SO WILL DAMAGE THE MOTOR MODULE AND VOID ALL WARRANTIES.
The Poseidon™ 80 is supplied with the following: 90 feet of heavy duty 10 gauge wire directly attached to the pump.
285 WATTS (MAX)
12-15 At Source
MAXIMUM AMP OUTPUT:
LENGTH 7.5" / DIAMETER: 1.82"
OPTIONAL CONTROLLER OR BOOSTER:
3/8" ID LOW DENSITY POLYETHYLENE TUBING
90 FEET OF HEAVY DUTY 10 GAUGE WIRE WITH ALLIGATOR CLAMPS