12 Volt Frontier™ 60

 

Pumping Depth (DTW)
Gallons Per Minute
10 2.25
20 2.00
30 1.65
40 1.30
50 1.00
60 0.50
70  0.00
80 0.00
 90 END OF WIRE

 

FINALLY!!

A 12 volt battery or solar operated submersible water pump that easily fits into a 2 inch well.


A revolutionary 12 volt pump: The Frontier™ 12 volt submersible pump by Proactive Environmental Products® is engineered for the home owner in mind. The Frontier series pump line will fit into a schedule 40 or 80 2inch well. There are two models that we have engineered. The first pump is called the Frontier 80 (pumps 80 feet depth to water). And the second pump is called the Frontier 60 (pumps 60 feet depth to water). So simple to install and operate: Just hose clamp onto the pump barb tip a 3/8" id polyethylene tubing (you can purchase the tubing from your local distributor or hardware store) and attach your desired suspension rope to the eye hook provided on top of the pump. Then, lower the pump to the desired water depth and energize the pump with a deep cycle marine battery and/or a small solar system. It is really that fast and that easy.


Easy to fix if a problem should arise: It is part of life.... all moving parts will break sooner or later. The Frontier pump series comes complete with a 1 year parts and labor warranty. Keep in mind... the life of the pump depends of course how often it is used (this is for any pump or a matter of fact anything mechanical). You should receive years of reliable service under normal working conditions. The great benefit of the Frontier Pump Series Is the patented (#7584785) replaceable motor module that can be changed out within 60 seconds. That means no down time and NO expensive service calls. Just twist in the new motor module and start pumping again, truly peace of mind!!. Once installed, your pump is essentially new and will have a life span identical to a new pump. Please note the Frontier pump ships to you with one motor module installed on the pump. If you need to purchase a back-up motor module please contact your Proactive Environmental Products® authorized distributor.


The Frontier 60 and 80 pumps are engineered for ease of use. The pumps consist of 4 components:

  1. The replaceable motor module
  2. The motor module housing top connector
  3. The outside pump housing
  4. The pump power wire

TESTS WERE CONDUCTED USING A 50 AMP DEEP CYCLE MARINE BATTERY THAT HAS A CONSTANT VOLTAGE OF 12.5 AT THE BATTERY TERMINALS.
DTW=DEPTH TO WATER OR TRUE PUMPING DEPTH. FOR EXAMPLE: IF THE STAGNANT WATER COLUMN IS 60 FEET, THEN THE PUMP WILL BE ABLE TO LIFT A TRUE 1.4 GPM PER MINUTE (REFERENCING THE Frontier 80) (PLUS OR MINUS A LITTLE BIT, DEPENDING UPON THE VOLTAGE OUTPUT OF THE BATERY).

The Frontier Pump series is constructed from ABS/PVC and Stainless steel.
Sometimes the specifications and color of the pumps will change without notice.
THE FRONTIER 60 PUMP WIRE MAY BE CUT DOWN TO ANY SPECIFIC LENGTH. BUT THE FRONTIER 80 PUMP YOU CANNOT CUT THE WIRE DOWN TO SHORTER LENGTHS.DOING SO WILL OVER AMP AND OVER VOLT THE MOTOR MODULE CAUSING PREMATURE FAILURE!!

WHEN USING THE FRONTIER 80 PUMP... ONLY USE THIS PUMP AT DEPTHS OF 40 FEET DTW OR DEEPER. FAILURE TO DO SO WILL DAMAGE THE MOTOR MODULE AND VOID ALL WARRANTIES.

19 Amp Draw at 10 feet depth to water. 13 Amp Draw at 80 feet depth to water. Note: GPM=GALLONS PER MINUTE

The Frontier™ 80 is supplied with the following: 90 feet of heavy duty 10 gauge wire directly attached to the pump.

Specifications

  • POWER CONSUMPTION:

    150 WATTS (MAX)

    VOLT RECOMMENDATION:

    12-15 At Source

    MAXIMUM AMP OUTPUT:

    10 AMPS

    MEASUREMENTS:

    LENGTH 7.5" / DIAMETER: 1.82"

    OPTIONAL CONTROLLER OR BOOSTER:

    NONE

    REQUIRED TUBING:

    3/8" ID LOW DENSITY POLYETHYLENE TUBING

    SUPPLIED WITH:

    90 FEET OF HEAVY DUTY 10 GAUGE WIRE WITH ALLIGATOR CLAMPS

0.0/5 rating (0 votes)

Share this product